Calculation of the dinamic model using code Quad4m in backgruond without the use of prompt DOS. This section Contains information about the model and the dynamic load applied. During the iterations can be controlled:
- Run: Number of iterations of the calculation;
- Step: Number of calculations for each iteration;
- Time: Time to dynamic loading;
- Check calculation: Check the control strain;
Multithreaded calculations of the equations of meshing. There is Speed increases that will vary from computer to computer based on number of processors, processor architecture, and available RAM.
Linear elastic analysis
For linear elastic analysis (without the use of the curves G / Go and D) is sufficient to use a single iteration of the calculation and the value of Check calculation is always equal to 1,000.
For Equivalent linear analysis the values of G / Go and Damp are updated according to the maximum strain of the element.
The iteration is performed with a check until there is no further deformation is calculation in the model and consequently the Check calculation is equal to 1,000. This means that the calculation iterations are sufficient to achieve the maximum strain on the model. Otherwise, the number of iterations choices are insufficient and the model is not correctly calculated.
Calculation 1 – Maximum deformation reached. Completed
Calculation 2 – Maximum deformation is not reached. Incomplete
Nessun commento:
Posta un commento